Image Annotation
Mark a specific change, write an instruction, and inspect a separate revision result.
Open the editor on a real result
An Image node with a visible result exposes an annotate/inpaint control on the preview. The annotation editor uses that current image as its source.
- Select an Image node that has completed generation, then click the annotate pencil on its preview.
- Inspect the full image in the editor before marking; if there is no preview, run or repair the source first.
Point to one precise change
The active editor offers Select, Arrow, Box, and Circle plus a color picker. A selected mark can have its instruction edited; use shapes to identify an area, not to paint directly onto the exported image.
- Choose Box and drag around the mug handle only; select the resulting mark and label it “replace handle with brushed steel.”
- Use Arrow for a small direction change or Circle for a compact region; avoid covering unrelated objects.
State what stays unchanged
The overall instruction supplements the visual marks. It should distinguish the requested edit from the parts to preserve, because the revision is a new model generation rather than a deterministic pixel operation.
- In Overall instruction, write “Change only the marked handle; preserve cup color, tabletop, shadows, and camera angle.”
- Read each mark label and the overall instruction together; remove contradictory wording before generating.
Generate a revision branch
Generate revision requires at least one annotation. It creates a separate Image revision node near the source and submits a revision request; marks describe changes but are not the final image overlay.
- After checking the source and annotations, click Generate revision once and wait for the new node to finish.
- Compare the source with the separate revision preview; connect the preferred image to the next node rather than assuming the original was overwritten.
If the edit misses the target
The editor supports deleting a selected mark, undoing a mark change, and clearing marks. These editor controls are for annotations; they do not roll back an already submitted provider result.
- If Generate revision is disabled, add a valid arrow, box, or circle and confirm the source image is loaded.
- If the output changes too much, make the marked area smaller, state preserved details explicitly, and check the revision node’s error before retrying.