Agent Approvals

Read a create preview

A create proposal lists planned steps and provides Choose position or Apply now. These controls operate on the entire proposed canvas patch; the steps are explanatory, not separate approval buttons.

1. 1.Check each planned node’s purpose and whether the requested media is represented.
2. 2.Choose position to place the whole patch on blank canvas, or Apply now to add it directly.

Audit an edit patch

Edit previews show counts for create, update, delete, connect and disconnect, plus operation details and up to three warnings. Apply changes commits the proposed patch as a whole.

1. 1.Compare deletion and disconnection counts with your instruction.
2. 2.If the scope is wrong, revise the request instead of approving a partial step.

Review organization proposals

An organization preview summarizes identified workflows and their node counts. Apply organization changes the canvas arrangement or graph according to the returned patch; it is not just a decorative label.

1. 1.Check that the listed workflows cover the intended nodes.
2. 2.Apply once and inspect the resulting layout and connections.

Treat a Skill preview separately

A built-in Skill preview may show duration, shot count, reference titles and a video prompt. Its Choose position action invokes that Skill path; it is not the same operation as approving a generic create plan.

1. 1.Inspect the reference list before activating the Skill.
2. 2.Cancel the Skill preview if the output or source material is wrong.

Separate layout approval from model runs

A canvas patch can create or change nodes without proving that every media model was run successfully. The separate autonomous path is not exposed by the current visible switch; some capabilities also have approval requirements.

• •Verify model, input type, duration and potential cost before starting a node.
• •If a provider task fails, inspect that node’s status rather than reapplying the same plan blindly.

Example: spot an unwanted deletion

Suppose the requested edit was to change one image prompt but the preview reports Delete: 2. The approval surface does not let you uncheck just those two operations.

1. 1.Do not click Apply changes.
2. 2.Restate “keep all existing nodes and connections; update only the selected image prompt” and review a new preview.

If Choose position seems to do nothing

For a create plan, Choose position closes the Agent panel and leaves a pending patch awaiting a canvas click. It does not immediately add the nodes.

• •Find an empty canvas area and left-click to commit placement.
• •Do not repeatedly request the same plan while the patch is still pending.